Angled control panel

Step 1 Preliminary information

We are going to assembly these parts. They are seen from behind.

Insert M3 square nuts in every slots.

Step 2A Mounting the angled panel (MK2/3 screen+ temperature control+LED)

Place and secure with M3 screws W-1219 component and Prusa screen.

Unplug switch wires, insert switch from the front, and plug back the wires.

Step 2B Mounting the angled panel (MK4 screen+temperature control+LED)

Insert Mn square nuts inevery slot.

Place and secure with M3 screws W-1219 component and Prusa screen.

Place and secure with a zip-tie the USB cable extender.

Unplug switch wires, insert switch from the front, and plug back the wires.

Assemble both side, add one M3*6 screw to maintain them together.

Add the L-shape part to the bottom with a M3*6 screw

Add the rotational knob by slightly pushing

Place and secure the assembly to the metal frame using M3*6 screws. Don’t forget the one under your enclosure! You may zip-tie cables.

Step 3 Attaching the temperature probe

You can choose between those two solutions :

• Use the temperature probe holder

The temperature probe holder will be attached behind the front bottom right hinge.

Unscrew a little bit screws of that hinge. Insert the probe holder, and tighten screws.

You may use a zip tie to hold the wire in place.

OR

• Zip-tie the probe to the bottom of your printer

Step 4 Attaching the power supply connector

Route cable as shown on the picture.

These are LED’s and fan’s wires

Install the power supply connector with a M3*12 screw. This is the connector for led and fan power supply

Clip cable protections

Install PSU cover with a M3x6mm screw