Motherboard cooling
Prusa MK4 with elastomer dampers
For Prusa MK2/MK3, see the second section, below.
Assembly time: 10min
Required kit elements:
- 5 pcs M3*6 screws
- 4 pcs M3 square nuts
- 16 cm of foam (around 6*2mm)
Printed parts in 19_Motherboard_cooling:
- 19_MK4_Motherboard_cooling_plate
- 19_mk4_motherboard_cooling_tube_bottom
- 19_mk4_motherboard_cooling_tube_top
Step 1 Preliminary information
You need to print the three files.
Step 2 Mounting the bottom part
Insert square nuts into each slots of the bottom tube.
Screw from under with 3*6 screws.
Add foam tape on the top edges.
Step 3 Funnel
Assemble the two other parts together, and wcrew with a 3*6 screw, without nut.
Step 4 Final assembly
Use the 4 m3*6 screws you removed from the motherboard plate to assemble your new plate.
Optional Add a fan
You can add a 40mm*40mm fan inside the bottom part.
Prusa MK2/MK3 with elastomer dampers
Assembly time: 5min
Required elements:
- 4 pcs M3*6 screws
- 4 pcs M3 square nuts
Printed part in 19_Motherboard_cooling:
- 19_Prusabox_mk3_einsy_board_cooling
Step 1 Preparing the part
You need to print this file, and insert 4 square nuts into each slots.
Step 2 Mounting the funnel
Screw from under with 3*6 screws.
Optional Add a fan
You can add a 40mm*40mm fan inside the bottom part.