Step 1 Prepare uprights
We will need in this steps the four identical uprights and these 4 printed parts, which are parts of bottom corners.
This side is the top
This side is the bottom
Bend slightly the two sections of the bottom of each uprights like in the picture. This will give springs to the metal, and allow you to assemble and disassemble the top easily.
Step 2 Assemble printed parts
On each bottom, screw very lightly the printed parts with M4 screws and nuts. Be carefull to the way:
Straight holes are going to the top
Titled holes are going to the bottom
Step 3 Assemble uprights
Using M4 screws, insert the four uprights to the top metal frame. Be carefull that metal parts are not overlapping.
Step 4 Prepare fixed hinges
First file includes all necessary hinges for L version.
If you have XL version, you need to print both files.
Print plates in “0MB_Modularbox” folder:
Split the two types of fixed hinges:
Type A: 8
Type B: 4
Type A: 11
Type B: 6
Insert M3 nuts in each slot
Insert a pin in each fixed hinge. This step might be tricky: use a plier to begin the insertion, then the edge of a table can help to push it through.
Step 4 Assemble fixed hinges
Pictures are of L version. With XL version, you have one more hinge for each side and back/front doors.
Type A. Use M3*6 screws. These two hinges are for top door. Don’t add them know if you want to install LED lights.
Type A. Use M3*6 screws.
Type B. For the left door, use M3*12 screws and add vertical cable rails clips between screw heads and metal frame.
Type B. Use M3*6 screws.