Printer’s feet
This page is divided in two sections:
Bear frame printer
Assembly time : 15 min
Necessary parts:
- M3 screws and nuts
- Elastomer dampers
Printed parts:
- Back feet: 2x 0MB_printer-feet_20x40_profil_elastomer_30mm_v1
- Front feet: 2x 0MB_printer-feet_20x20_profil_elastomer_11mm_v1
Step 1 Prepare feet
Insert M3 nuts into each slots.
Screw dampers inside printed parts.
Be carreful to screw dampers perpendicular to printed part in both direction.
Remove feet if you have any on your printer.
Step 2 Install printer’s feet
Place back feet on back frame, the most apart possible.
Place front feet on sides frames: distance between inside frame and first edge of feet is 46mm.
Secure feet with M3*12 screws.
Caribou printer
Assembly time : 15 min
Necessary parts:
- M3 screws and nuts
- Elastomer dampers
Printed parts:
- 4x 0MB_printer-feet_30mm_profil_elastomer_spacer_v1
Step 1 Prepare feet
This Caribou’s nut goes inside frame’s groove
Printed part goes under the frame
Elastomer dampers is crewed inside nut
Step 2 Install printer’s feet
Turn your printer to have the bottom accessible. Place the front on your table.
Place back feet on back frame, the most apart possible.
Place front feet on sides frames: distance between outside frame and first edge of feet is 78mm.
Secure feet with M3*12 screws.