Pre-assembled Prusabox Pro-pack assembly guide

On this guide, we will help you to complete the assembly of you Prusabox Pro Pack. It will take you 1h.

For each chapter, we will ask you to follow the regular assembly guide. There are some differences, that are detailed in each following paragrphs.

You don’t need to go through chapter 1 and 2.

Chapter 3: Printer positioning

Click here to access to regular chapter 3:

3. Printer
positioning

Steps 13-14-15-16: Follow the guide for angled panel assembly instead.

Angled panel

assembly

Step 23:

Pre-assembled pro-pack (4)
Pre-assembled pro-pack (6)
Pre-assembled pro-pack (5)
Pre-assembled pro-pack (4) Pre-assembled pro-pack (6) Pre-assembled pro-pack (5)

Route cable as shown on the picture.

These are LED’s and fan’s wires

Install the power supply connector with a M3*12 screw. This is the connector for led and fan power supply

Clip cable protections

Install PSU cover with a M3x6mm screw


 

Chapter 4: Install uprights

Pre-assembled pro-pack (1)
Pre-assembled pro-pack (2)
Pre-assembled pro-pack (3)
Pre-assembled pro-pack (1) Pre-assembled pro-pack (2) Pre-assembled pro-pack (3)

Install uprights on the upper part:

Slide down each upright on the corner. Metal parts should not overlap.

Screw tightly every corner.

Spool holder

You may install the inside spool holder now. Follow this guide.

Inside

spool holder

Chapter 5: Final assembly

Click here to access to regular chapter 4:

5. Final
assembly

Pre-assembled pro-pack (7)
Pre-assembled pro-pack (8)
Pre-assembled pro-pack (7) Pre-assembled pro-pack (8)

Flip the cover on the plateform. Make sure all corners are correctly inserted before sliding down the top.

 Screw each corners.

Then you must plug fan’s and LED’s wires, clip the vertical cable cover, and add doors.


 

Recommendations

Instructions:

Please keep those instructions close by while assembling your printer-box: you may need to click on some of the pictures or watch our video tutorials.

Handling the printer: 

Do not risk getting burned: wait until the printer has cooled down before handling it.
Always handle your 3D printer with care: the tray moves easily.

People required for assembly:

You can do this on your own.

Work area:

Set up on a stable table or work surface that can ideally be walked around.
If you can’t navigate around your table, that’s okay, you may have to orientate your printer-box differently but you won’t break your back.

Non supplied material:

To mount the printerbox, you can use the tools supplied with the Prusa printer:

  • 2mm hex key
  • 2.5mm hex key
  • clamp