LED lights

Upgrade your enclosure with lights for improving your enclosure’s look, and to improve visibility while printing with a camera.

This is the V2 of that mod. We made it easier to assemble, with less parts. You can find the old assembly guide here.

Assembly time: 15 min

Components:

  • LED available on our shop here
  • Soldering iron or wire connectors
  • You can find everything you need for electrical set up here
  • Or go to our shop to buy the electrical wiring harness fully equipped here

Printed parts:

  • Mods > LED (right rail is a symmetry of left rail)

Assembly:

Step 1 Preliminary information

You will need all these components.

Working on the enclosure’s upper part dissassembled is a lot easier.

These are the front parts

These are the left parts (they will be on the left once your enclosure is fully assembled)

These are the right parts (they will be on the right once your enclosure is fully assembled)

Step 2 Led’s frame assembly

Assemble each led’s frame side

Step 3 Main assembly

004_led (3)
004_led (4)
004_led (5)
004_led (3) 004_led (4) 004_led (5)

Screws the ends with M3*12 screws

Screw the adjustable lock with a M4 screw, screw’s head goes on the enclosure’s outside.

For the front part, use M3*12 screws, screw’s head goes on the enclosure’s inside. Hinges on the outside are used as nuts.

Step 4 Adding LED

004_led (6)
004_led (7)
004_led (8)
004_led (6) 004_led (7) 004_led (8)

Begin by the front and the middle. Remove the protection paper and stick the LEDs.

Add a clip on each end. Make sure to place it between two LEDs (LEDs are the yellow dots)

Continue by adding LEDs on each side, and clips to each ends.

Go to the electrical wiring part here